clsim_lib.h File Reference

(git 7dacc10118, 2024-12-02)

#include "libpdv.h"

Functions
void	pdv_cls_dump_state (PdvDev pdv_p)
	Prints the board state to stdout. More...
void	pdv_cls_dump_geometry (PdvDev pdv_p)
	Prints board geometry only to stdout. More...
int	pdv_cls_set_dep (PdvDev pdv_p)
	Initializes CLS values based on PdvDependent structure in pdv_p. More...
int	pdv_cls_dep_sanity_check (PdvDev pdv_p)
	Checks for inconsistencies in the configuration completed by pdv_cls_set_dep(). More...
void	pdv_cls_set_size (PdvDev pdv_p, int taps, int depth, int width, int height, int hblank, int totalwidth, int vblank, int totalheight)
	Set the width and height of the simulator frame. More...
void	pdv_cls_set_line_timing (PdvDev pdv_p, int width, int taps, int Hfvstart, int Hfvend, int Hlvstart, int Hlvend, int Hrvstart, int Hrvend)
	Set the values for frame valid (FVAL), line valid (LVAL), and read valid (RVAL) timing. More...
void	pdv_cls_set_linescan (PdvDev pdv_p, int state)
	When set, once the start-of-frame conditions are met, the simulator runs forever, emulating a linescan camera (as if the total vertical active and total vertical count maximum were set to infinity.) More...
void	pdv_cls_set_lvcont (PdvDev pdv_p, int state)
	Enable/Disable line valid timing during vertical blanking. More...
void	pdv_cls_set_rven (PdvDev pdv_p, int state)
	Enable/Disable ReadValid Enable (RVEN); if enabled allows image width padding (with dummy data from the Fill register values), to output an image that is wider than the actual image data provided. More...
void	pdv_cls_set_uartloop (PdvDev pdv_p, int state)
	Enable/Disable UART looping (echo) of serial data; if enabled allows testing of the serial port on an EDT Framegrabber. More...
void	pdv_cls_set_smallok (PdvDev pdv_p, int state)
	Enable/Disable CLS FIFO for small (less than 16 KB) images. More...
void	pdv_cls_set_intlven (PdvDev pdv_p, int state)
	Enables or disables four-tap interleaving (the four-tap re-ordering of 8-bit pixel values). More...
void	pdv_cls_set_firstfc (PdvDev pdv_p, int state)
	Enable/Disable frame count in the first word of each frame. More...
void	pdv_cls_set_datacnt (PdvDev pdv_p, int state)
	Enable/Disable internal image data generation; allows image data to come from the counters instead of the DMA stream. More...
void	pdv_cls_set_led (PdvDev pdv_p, int state)
	Controls state of the board's green LED. More...
void	pdv_cls_set_trigsrc (PdvDev pdv_p, int select)
	Selects which input pins to look at for external trigger; CC1 or CC2. More...
void	pdv_cls_set_trigpol (PdvDev pdv_p, int polarity)
	Set the trigger polarity. More...
void	pdv_cls_set_trigframe (PdvDev pdv_p, int state)
	Enable/Disable frame-valid triggering; if enabled CLS waits at the start of each frame until a trigger is detected. More...
void	pdv_cls_set_trigline (PdvDev pdv_p, int state)
	Enable/Disable line-valid triggering; if enabled CLS waits at the start of each raster until a trigger is detected. More...
void	pdv_cls_sim_start (PdvDev pdv_p)
	Clear the CFG register including the FIFO_RESET bit (bit 3, 0x08) which clears the FIFO and starts the CLS. More...
void	pdv_cls_sim_stop (PdvDev pdv_p)
	Set the CFG register FIFO_RESET bit (bit 3, 0x08) which stops the CLS. More...
void	pdv_cls_init_serial (PdvDev pdv_p)
	Re-intializes and enables the serial communication. More...
void	pdv_cls_set_height (PdvDev pdv_p, int height, int vblank)
	Set the height of outgoing frames, as well as the number of blank lines (vblank) between valid lines. More...
void	pdv_cls_set_width (PdvDev pdv_p, int width, int hblank)
	Set the width of outgoing frames, as well as the number of blank columns (hblank) between valid columns. More...
void	pdv_cls_set_width_lval_rval (PdvDev pdv_p, int width, int hblank, int hlvstart, int hlvend, int hrvstart, int hrvend)
	Set the width of outgoing frames, as well as the number of blank columns (hblank) between valid columns, start and end of both line valid and read valid. More...
void	pdv_cls_set_depth (PdvDev pdv_p, int value)
	Set the depth of outgoing frames. More...
void	pdv_cls_set_clock (PdvDev pdv_p, double freq)
	Set the pxiel clock frequency (in MHz). More...
void	pdv_cls_set_fill (PdvDev pdv_p, uint8_t left, uint8_t right)
	Set the left and right fill values when RVEN (pdv_cls_set_rven()) is enabled. More...
void	pdv_cls_set_readvalid (PdvDev pdv_p, uint16_t HrvStart, uint16_t HrvEnd)
	Set the horizontal start and end positions if RVEN (pdv_cls_set_rven()) is enabled. More...
void	pdv_cls_set_dvalid (PdvDev pdv_p, uint8_t skip, uint8_t mode)
	Set the values for Data Valid (DVAL) timing. More...
void	pdv_cls_setup_interleave (PdvDev pdv_p, short tap0start, short tap0delta, short tap1start, short tap1delta, short tap2start, short tap2delta, short tap3start, short tap3delta)
	Set the start address and delta for each tap. More...
int	pdv_cls_get_vgap (PdvDev pdv_p)
	Computes the vertical gap (vgap/vblank) value. More...
int	pdv_cls_get_hgap (PdvDev pdv_p)
	Computes the horizontal gap (hgap/hblank) value. More...
double	pdv_cls_frame_time (PdvDev pdv_p)
	Computes the frame time in milliseconds. More...

Detailed Description

Copyright

Copyright (C) 2011 Engineering Design Team, Inc.

Camera Link Simulator Library header file, for use with the EDT CameraLink Simulator (CLS).